Using the alarm feature in SofTest-M

May 26, 2016 Kelly Basara

SofTest M provides the capacity to set up to six independent alarms. The alarm will count down in seconds until it reaches the one minute mark. It then becomes five second intervals.
 

To set an alarm, hit the Alarm icon in the Action Bar, and select an available location.

STMAlarm.png


Now select Add Alarm. Specify the interval of the alarm by swiping upward to lower the duration or swiping down to increase it. Once the correct time is highlighted, hit Add Alarm to add it.

STMAlarm.png  STMAlarm.png

To delete an alarm, hit the Alarm icon in the Action Bar and slowly swipe your finger to the right of the alarm you wish to delete. Press Delete to remove the alarm.

DeleteAlarm.png

Previous Article
What are the minimum system requirements to use SofTest-M (iPad)?
What are the minimum system requirements to use SofTest-M (iPad)?

Included are the minimum system requirements for using SofTest-M on an iPad

Next Article
How do I use Guided Access mode?
How do I use Guided Access mode?

To set up Guided Access: On your iPad, navigate to Guided Access by going to Settings > General > Accessibi...